Lincoln Electric SVM207-A service manual Reassembly Procedure

TOC

TOC

F-51 TROUBLESHOOTING AND REPAIR F-51

ENGINE/ROTOR REMOVAL AND REPLACEMENT PROCEDURE (cont.)

Return to Section

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master

Return to Master TOC

Return to Master TOC

Return to Master TOC

REASSEMBLY PROCEDURE

NOTE: Lincoln Electric recommends that a new bear- ing be installed when you replace the rotor and blower assembly.

1.Clean the tapered engine crankshaft. Slide the rotor onto the shaft.

2.Insert the rotor thru-bolt, and with the torque wrench tighten the bolt to 50 ft lbs.

3.Support the engine/rotor assembly with the chain hoist. Fit the rotor into the stator frame, being careful not to damage the rotor core against the stator. The bearing will seat into its race about half way.

4.Insert the four bolts and lock washers that hold the engine to the stator. With the 9/16” wrench, draw the bolts up evenly in order to seat the bearing properly. Tighten to 22 ft-lb. moving diagonally from bolt to bolt.

5.Check the rotor-stator air gap with the .017 feeler gauge. The measurement is taken at the blower end of the rotor before the fan is reinstalled. Turn the rotor with a pair of locking pliers as necessary so that the rotor “iron” is up to take the measure- ment. (The rotor has two flat sides, which are not measured for air gap.) Slide in the gauge. Then rotate the shaft 180 degrees and measure again. If the gauge does not clear, loosen the four engine/stator bolts; retighten the bolts and recheck the air gap. Repeat until the proper .017 minimum air gap is achieved.

6.Fasten the ground lead to the right engine mount- ing bolt and install both bolts.

7.Install the brush holder bracket back into the sta- tor frame. See the Brush Removal and Replacement Procedure in this section of the manual.

8.Attach leads to the oil pressure switch refer to wiring diagram. Replace any cut cable ties.

9.Unplug the fuel tank connection and fuel hose and connect them.

10.Connect the idle linkage to the idler rod. Snap the plastic clip back into place.

11.Connect the engine choke cable at the position marked during disassembly.

12.Screw the blower fan back onto the end of the rotor shaft. Be sure the washer is in place and hand tighten the fan only.

13.Reposition the vertical fan baffle and secure it with the two screws.

14.Install the two cowling covers at the rear of the sta- tor.

15.Connect the black plug in front of the fuel tank fill spout.

16.Connect the leads to the starter solenoid and replace any cable ties cut during disassembly.

17.Install the battery. Connect the positive battery cable, then the negative battery cable. BE SURE TO CONNECT THE POSITIVE BATTERY CABLE FIRST.

18.Replace the battery cover.

19.Reinstall the case side, fuel cap, lift bail gasket, and case top. Connect the spark plug wires.

20.See the Retest after Repair Procedure, the fol- lowing topic in this section of the manual.

RANGER® 3 PHASE