
Instant EtherFast® Series
connected directly to the Switch when its buffers fill. When enabled, back pressure is used for half duplex and IEEE 802.3x for full duplex.
Note: Flow control should not be used if a port is connected to a hub.
• Jack Type - Shows the jack type for each port. Ports
Select Apply to make changes. Select OK to return to the previous panel. Select Cancel to cancel any changes. Select Prev Page to view the previous page. Select Next Page to view the next page.
Mirror Port Configuration
The Mirror Port Configuration screen allows you to mirror traffic from any source port to a target port for
•Enable Port Mirror - Enables or disables the mirror function.
•Mirrored Ports (Tx/Rx) - The port whose transmitted or received traffic will be mirrored. Press Add to specify mirrored ports.
EtherFast® Layer 3 Management
•Monitor Port - The port that will duplicate the transmitted or received traffic appearing on the mirrored port.
Note: You can mirror multiple ports to a single port to view traffic such as that crossing a port trunk. However, note that some packets may be dropped for moderate to heavy loading.
Select Apply to make changes. Select OK to return to the previous panel. Select Add to add a port.
Port Trunking Configuration
Ports can be combined into an aggregate link to increase the bandwidth of a network connection or ensure fault recovery. You can configure trunks between any two switches. The
•Index - The trunk identifier.
•Port Count - Trunks can contain 2, 4, or 8 ports.
•Port Number - The ports assigned to each trunk.
Select OK to return to the previous panel. Select Add to add a trunk.
36 | 37 |