Instant EtherFast® Series

Subnet Configuration: Modify RIP Configuration

The Subnet Configuration: Modify RIP Configuration screen allows you to modify the RIP parameters.

Authentication Type - Authentication can be used to ensure that routing information comes from a valid source.

Authentication Key- A simple password must be provided if authen- tication is enabled. It is case-sensitive and can have up to 16 charac- ters.

Send Type - Select the type of protocol used for traffic sent from this port.

Receive Type - Select the kind of routing protocol messages accepted on this port.

Default Metric - This is used for the default route in RIP updates originated on this interface. A value of zero indicates that no default route should be originated.

Poison Reverse - This propagates routes back to an interface port from which they have been acquired, but it sets the distance vector metrics to infinity.

Select Apply to make changes. Select OK to return to the previous panel. Select Cancel to cancel any changes.

EtherFast® Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch

Subnet Configuration: Modify OSPF Configuration

The Subnet Configuration: Modify OSPF Configuration screen allows you to modify the OSPF parameters.

Area ID - A 32-bit number assigned to each interface or subnet run- ning the OSPF protocol.

Router Priority - When two routers are attached to a network, both attempt to become the designated router, and the one with the highest priority takes precedence.

Interface Cost - The cost of sending a packet on the interface.

Transit Delay - The estimated number of seconds it takes to transmit a Link State Update Packet over this interface.

Retransmit Interval - The number of seconds between LAS retrans- missions, for adjacencies belonging to this interface.

Hello Interval - The length of time, in seconds, between the Hello Packets that the router sends on the interface.

Dead Interval -After ceasing to hear a router’s Hello Packets, the number of seconds before its neighbors declare the router to be down.

52

53

Page 30
Image 30
Linksys EF1324 manual Subnet Configuration Modify RIP Configuration, Subnet Configuration Modify Ospf Configuration