Instant EtherFast® Series
VLAN Table Configuration
The VLAN Table Configuration screen is used to create a new VLAN or modify the settings for an existing VLAN.
•VLAN - The ID for the VLAN currently displayed. The range is
•Port - Port entries may be marked as:
–(Normal) Uses GVRP to determine port membership.
S(Static) Adds port as a static entry. GVRP protocol is dis- abled.
R(Registration Fixed) Adds port as a static entry. GVRP protocol messages are still forwarded through this port.
X(Forbidden) Disables GVRP for this VLAN on the specified port.
Select Apply to make changes. Select OK to return to the previous panel. Select Prev Page to view the previous page. Select Next Page to view the next page. To display a specific page, set the page number in the Page field and then press Apply. Select Add to add a VLAN.
EtherFast® Layer 3 Management
IP Menu
The IP Menu is used to configure the IP subnets for each VLAN on your Switch, the unicast and multicast routing protocols, and IGMP. This menu is only available for a Switch in multilayer mode.
•Subnet Configuration - Specifies the IP interface for VLANs configured on this Switch, including the subnet address and routing protocols.
•Protocol Configuration - Enables the unicast and multicast routing proto- cols globally for this Switch.
•Static ARP Configuration - Specifies the static Address Resolution Protocol.
•Static Route - Configures a static route.
•Default Route - Defines the router to which this Switch will forward all traf- fic for unknown networks.
Select OK to return to the previous panel.
48 | 49 |
