Chapter 6: Programming Information | A794 Owner’s Guide |
Horizontal Positioning Commands
The horizontal positioning commands control the horizontal print positions of characters on the receipt.
The commands describe operation for 80 mm paper. If the printer supports 82.5 mm paper, the dot spacing is the same but there are 640 printable dots rather 576 printable dots on the 80 mm paper.
Horizontal Tab
ASCII HT
Hexadecimal 09
Decimal 9
Moves the print position to the next tab position set by the Set Horizontal Tab Positions (1B 44 n1 n2 ... 00) command. The print position is reset to column one after each line.
Tab treats the left margin as column one, therefore changes to the left margin will move the tab positions.
When no tabs are defined to the right of the current position, or if the next tab is past the right margin, Line Feed is executed. HT has no effect in Page Mode.
Print initialization sets 32 tabs at column 9, 17, 25…
Set Column
ASCII | ESC DC4 n |
Hexadecimal | 1B 14 n |
Decimal | 27 20 n |
Value of n: | |
| |
Default of n: | 1 |
Prints the first character of the next print line in column n. It must be sent for each line not printed at column one. The value of n is set to one after each line.
Exceptions
This command cannot be used with Single- or
Related Information
This is ignored in
72 | December 1999 |