M-S Cash Drawer A794 Select Paper Sensors to Output Paper End Signals, Range of n, Default of n

Chapter 6: Programming Information A794 Owner’s Guide

Select Paper Sensors to Output Paper End Signals

ASCII	ESC c 3 n
Hexadecimal	1B 63 33 n
Decimal	27 99 51 n

Value of n:

If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor outputting paper-end signals.

If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor outputting paper-end signals.

Bit	Position	Hex	Decimal	Function
0	Off	00	0	Paper roll near-end sensor disabled
	On	01	1	Paper roll near-end sensor enable
1	Off	00	0	Paper roll near end sensor disabled
	On	02	2	Paper roll near end sensor enabled
2	Off	00	0	Paper roll end sensor disabled
	On	04	4	Paper roll end sensor enabled
3	Off	00	0	Paper roll end sensor disable
	On	08	8	Paper roll end sensor enabled
4, 5, 6, 7	-	-	-	Undefined
Range of n:	1-255

Default of n: 12

Specifies the paper sensor to output a paper end signal. Multiple sensors may be selected to signal when paper has run out. When multiple sensors have been selected, anytime one of the sensors detects a paper end, the paper end signal is output.

When this command is executed a sensor is switched. The paper end signal switching is delayed depending on the receive buffer state.

Exceptions

This command can only be used with a parallel interface.

The command is ignored if it used with a serial interface.

64 December 1999