A794 Owner’s Guide | Chapter 6: Programming Information |
Character Width Selection
Hex | Decimal | Width | |
00 | 0 | 1 | (normal) |
10 | 16 | 2 | (two times width) |
20 | 32 | 3 | (three times width) |
30 | 48 | 4 | (four times width) |
40 | 64 | 5 | (five times width) |
50 | 80 | 6 | (six times width) |
60 | 96 | 7 | (seven times width) |
70 | 112 | 8 | (eight times width) |
|
| ||
Character Height Selection |
| ||
|
|
| |
Hex | Decimal | Height | |
00 | 0 | 1 | (normal) |
01 | 1 | 2 | (two times height) |
02 | 2 | 3 | (three times height |
03 | 3 | 4 | (four times height) |
04 | 4 | 5 | (five times height) |
05 | 5 | 6 | (six times height) |
06 | 6 | 7 | (seven times height) |
07 | 7 | 8 | (eight times height) |
This command is effective for all characters (except for HRI characters).
In Standard Mode, the vertical direction is the paper feed direction, and the horizontal direction is perpendicular to the paper feed direction. However, when character orientation changes in 90 degree
In Page Mode, vertical and horizontal directions are based on the character orientation. When characters are enlarged with different sizes on one line, all the characters on the line are aligned at the baseline.
The Select Print Mode (1B 21 n) command can also select or cancel
Exception
If n is out of the defined range, this command is ignored.
Related Information
In A793 Emulation, this command is discarded and not put into print buffer.
December 1999 | 89 |
