Chapter 6: Programming Information | A794 Owner’s Guide |
Real Time Commands
The Real Time commands provide an application interface to the printer even when the printer is not handling other commands
♦Real Time Status Transmission: GS (Hex 1D) Sequence and DLE (Hex 10) Sequence
♦Real Time Request to Printer: GS (Hex 1D) Sequence and DLE (Hex 10) Sequence
♦Real Time Printer Status Transmission
The Batch Mode Printer Status commands are placed in the printer’s data buffer as they are received and handled by the firmware in the order in which they were received. If the paper exhausts while printing data that was in the buffer ahead of the status command, the printer goes busy at the
The Real Time commands are implemented in two ways in order to overcome the limitations of Batch Mode Status commands. Both implementations offer the same functionality; which one you choose depends on the current usage of your application.
Preferred Implementation
For a new application the GS (1D) sequences are recommended to avoid possible misinterpretation of a DLE (0x10) sequence as a Clear Printer (0x10 0, ASCII DLE NUL) command.
An application using these GS (1D) sequences, does not need to distinguish for the printer between the new real time commands and the Clear Printer command. This implementation is ideal for an existing A756 application that already uses the Clear Printer command or for a new application being developed.
Alternate Implementation
The alternate implementation uses the DLE (0x10) sequences as implemented on other printers. An application using these DLE (0x10) sequences and the original A756 Clear Printer command (0x10) must distinguish for the printer between the new real time commands and the Clear Printer command by adding a NUL (0x00) to the Clear Printer command.
An application using these DLE (0x10) sequences must also send the second byte of the sequence within 100 milliseconds of the first, to prevent the first byte being mistaken for a Clear Printer command.
110 | December 1999 |
