ENGLISH

Symbols used to indicate buttons in this guide

Button located on both the main unit and the remote control

BUTTON

Button only on the main unit <BUTTON>

Button only on the remote control [BUTTON]

<ENTER>

u/i p

[MENU]

u [ENTER/MEMO]

p

i

[NUMBER]

Setting the network [Network]

When using this unit with the broadband router’s DHCP function enabled, this unit automatically performs the IP address setting and other settings.

When using this unit connected to a network with no DHCP function, make the settings for the IP address, etc., at “Network connecting (DHCP=Off)” (vpage 30).

NOTE

When setting manually, check the setting contents with the network administrator.

Network connecting

1 Connect the LAN cable.

(vpage 8 “Connecting to a home network (LAN)”)

2 Turn on this unit.

(vpage 11 “Turning the power on”)

3 Press [MENU].

Turns on the Menu settings mode and the Menu appears on the display. (vpage 26 “Menu map”)

4Use uito select “Network”-“Connecting”-“DHCP (Off)”, then press [ENTER/MEMO], <ENTER> or p.

“DHCP” menu appears.

• When the network connection is set to “DHCP (On)”, go to step 6.

5Use uito select “On”, then press [ENTER/MEMO],

<ENTER> or p.

“Connecting” menu appears.

6Use uito select “Connection”, then press [ENTER/ MEMO], <ENTER> or p.

The connection starts.

When the connection is made successfully, “Succeeded” appears. If the connection fails, “Failed” appears.

NOTE

You may need to set the network connection manually, depending on the provider you use. To set the connection manually, use the setting

procedure of “Network connecting 'DHCP=Off)”.

Network connecting (DHCP=Off)

1Perform steps 1 to 4 of the “Network connecting” procedure and select “Off” in step 5.

“Connecting” menu appears.

2Use uito select “IP Address”, then press [ENTER/ MEMO], <ENTER> or p.

“IP Address” input menu appears.

3Use uipor [NUMBER] (0 – 9) to input the address and press [ENTER/MEMO] or <ENTER>.

4Use uip or [NUMBER] (0 – 9) to input the address for Subnet Mask, Gateway, Primary DNS, and Secondary DNS.

5After you input all required addresses, perform step 6 of “Network connecting” to connect to the Internet.

30

Page 34
Image 34
Marantz M-CR603 manual Setting the network Network, Network connecting DHCP=Off