ENGLISH
Set up speakers (Audyssey® Auto Setup)
Preparation
Step 1 | Step 2 |
Speaker Detection | Measurement |
|
|
|
|
•In step 1, you will perform measurements at the main listening position.
•This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency. It also corrects distortion in the listening area.
• In step 2, you will perform measurements at |
multiple positions (two to six positions) other than |
the main listening position. |
• You can achieve a more effective correction of |
When the setup microphone is connected, the following screen is displayed.
at ear height at
main listening position.
F.Height : Measure
Front Sp. : A
Amp Assign: Normal
Start
Cancel [ENT]:Select [RTN]:Back
The setting method for
When measuring begins, a test tone is output from each speaker.
• Measurement requires several minutes.
“Cancel Auto Setup?” is displayed on the TV screen. If “Yes” is selected, “Audyssey Auto Setup” closes.
Step1:Speaker Detection
MultEQ
Front Sp. :Yes
Center Sp. :Yes
Subwoofer :Yes
Surround Sp. :Yes
S.Back Sp. :Yes
Next
Retry
[ENT]:Next
NOTE
If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection.
NOTE
If “Caution” is displayed:
Go to “Error messages” (vpage 10), check any related items, and perform the necessary procedures.
If the problem is resolved, return and restart “Audyssey Auto Setup”.
Press ui to select “Retry”, and then press
Press ui to select “Cancel”, then press ENTER. Press o p to select “Yes”, then press ENTER.
Repeat the operation from step 4 of Preparation .
distortion within the listening area by performing |
measurements at multiple positions. |
8 Move the setup microphone to position 2, use ui to select “Next”, and then press ENTER.
The measurement of the second position starts. Measurements can be made in up to six positions.
Step2:Measurement
MultEQ Please place microphone at ear height at
2nd listening position.
Next
Calculate
Cancel
[ENT]:Next
If you want to omit measurements from the next position onward, select “Calculate”.
(Go to Step 3 Calculating )
When measurement of position 6 is completed, a “All the measurements were finished.” message is displayed.
Step2:Measurement
MultEQ
All the measurements were finished.
Calculate
Retry
Cancel
[ENT]:Calculate
8
Remote control operation | Move the cursor | Confirm the setting | Return to previous menu | |
buttons | (Up/Down/Left/Right) | |||
|
|