ENGLISH
1 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice.
The back light flashes.
2 Press the
When the procedure is successful, the
SEND indicator blinks twice.
NOTE
If the indicator did not blink twice, then repeat steps 1 and 2 and try entering the same code again.
1
2 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice.
The back light flashes.
3 Aim the remote control at the appliance and slowly alternate between pressing INPUT d and the input source select buttons for the appliance.
1 Press and hold down the input source select buttons for appliance to control, and press SET until the SEND indicator blinks twice and back light flashes.
The back light flashes.
The SEND indicator blinks twice.
Count the number of times the SEND indicator blinks (e.g. 3 blinks = 3) and write down the number.
4 Then press 2 to check the second digit of the code. Now press 3 and 4 to check the third and fourth digits of the code.
NOTE
If a code digit is “0”, the SEND indicator does not blink.
Registering preset codes
1 Press and hold down the input source select buttons for appliance to control and press SET until the SEND indicator blinks twice.
The back light flashes.
TV : 1000
DVD : 2000
CD : 3000
SAT : 4000
BD : 5000
The indicator will blink twice.
NOTE
After this procedure, the selected source reset to its initial code.
56