PhoneAccess™ User's Guide
This exciting feature allows you to call your XR20 system from any outside
How it works
1.From a touchtone phone, call the XR20 system's phone number.
2.The XR20 answers and sounds a short ready tone. You now have 8 seconds to enter a valid Master user code. If the user code is accepted by the panel, you will hear one or more beeps giving you the current armed status of the system. (You can also find out the armed status of the system by pressing the * key at any time.)
If | You will hear |
All areas are armed | 3 short beeps |
Area 1 (Perimeter) is armed | 1 short beep |
Any area is armed | 2 short beeps |
All areas are disarmed | 1 long beep |
If the user code is not accepted by the panel, you will hear four short beeps. Check the user code and try again. After 3 unsuccessful attempts to enter the code, the panel locks out PhoneAccess™ until a valid user code is entered at a keypad.
3.Once the user code is accepted by the panel and the armed status is given, you can enter the following commands:
Press | To do this | You will hear |
#, 1 | Arm all areas | 3 short beeps |
#, 2 | Arm area 1 | 1 short beep |
#, 3 | Arm areas 1 & 2 | 2 short beeps |
#, 0 | Disarm all areas* | 1 long beep |
#, 5, 4, 0, n* | Toggles the output | 1 short beep = on |
(* Use outputs 1, 2, 3, or 4 in place of n) | 1 long beep = off | |
|
| 4 short beeps = restricted |
|
|
|
Note: Faulted zones are force armed when the area arms.
Press |
| To do this | You will hear | |
# | then | 1 | Arm all areas | 3 short beeps |
# | then | 2 | Arm area 1 | 1 short beep |
# | then | 3 | Arm areas 1 & 2 | 2 short beeps |
Note: Zones in a bad condition are force armed when the area arms. | ||||
# | then | 0 | Disarm all areas | 1 long beep |
#, 5, 4, 0, n* | Toggles the output | 1 short beep = on | ||
(* Use outputs 1, 2, 3, or 4 in place of n) 1 long beep = off | ||||
| (Enter output descriptions below) | 4 short beeps = restricted | ||
1._________________________ 3. _________________________
2._________________________ 4. _________________________
PhoneAccess™ Quick Commands
Press |
| To do this | You will hear | |
# | then | 1 | Arm all areas | 3 short beeps |
# | then | 2 | Arm area 1 | 1 short beep |
# | then | 3 | Arm areas 1 & 2 | 2 short beeps |
Note: Zones in a bad condition are force armed when the area arms. | ||||
# | then | 0 | Disarm all areas | 1 long beep |
#, 5, 4, 0, n* | Toggles the output | 1 short beep = on | ||
(* Use outputs 1, 2, 3, or 4 in place of n) 1 long beep = off | ||||
| (Enter output descriptions below) | 4 short beeps = restricted | ||
1._________________________ 3. _________________________
2._________________________ 4. _________________________
Cut along dotted lines
XR20 Appendix | 35 |
