Maxon Telecom WL7-VERS. C-1K installation instructions Install Main Circuit Breaker

INSTALL MAIN CIRCUIT BREAKER

!WARNING

To prevent personal injury and equipment damage, make sure power is discon- nected from Lift when installing electrical parts.

NOTE: Apply dielectric grease on all electrical connections after all electrical cables are connected.

FAX (888) 771-7713

1.Attach 90 amp main circuit breaker (Kit item) to vehicle so power cable (Kit item) is within reach of the battery, as follows. Find a place to attach bracket (FIG. 29-1). (Note: The power cable must be able to reach between 90 amp circuit breaker and (+) battery terminal without straining the con- nections.) Attach 90 amp circuit breaker to brack- et. Next, attach bracket to vehicle with four (4) #12 self-drilling screws (Kit items).

1/4”-20

LOCK NUT (2 PLACES)

POWER UNIT

(REF)

1/4” FLAT

WASHER

(2 PLACES)

BATTERY

2 AWG POWER

CABLE (SHORT CABLE)

90 AMP MAIN CIRCUIT BREAKER

1/4”-20

CAP SCREW

(2 PLACES)

#12 SELF-DRILLING SCREW (4 PLACES)

2 AWG POWER CABLE (LONG CABLE CONNECTED BETWEEN TERMINAL OF STARTER SOLENOID AND MAIN CIRCUIT BREAKER)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116

MAIN CIRCUIT BREAKER & CABLING

FIG. 29-1

29 PATENTS PENDING