11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
8. Make sure platform lowers all the way to the ground and platform lights are illuminated while platform is lowering. Press DOWN button on the hand pendant to lower platform to the ground. As the plat- form is lowering:
•Controller must display DOWN
•Platform lights must be illuminated
When the platform reaches the ground:
•Controller must display GROUND
•Outboard rollstop must lower to the ground
9. Make sure platform will not raise more than 3” above the ground if the outboard rollstop is not up all the way. Stand on the outboard rollstop to keep it from moving to the up position. Press UP button on hand pendant to raise platform. As the platform is raising:
•Controller must display OUTBD SW
•Platform must stop raising at no more than 3” above the ground
Press the DOWN button on the hand pendant to lower platform to the ground. Move off the outboard rollstop before proceeding to the next check.
10. Make sure platform raises from the ground all the way to vehicle floor level and platform lights are il- luminated while platform is raising. Press UP button on the hand pendant to raise platform to vehicle floor level. As the platform is raising:
•Controller must display UP
•Platform lights must be illuminated
When the platform reaches vehicle floor level:
•Controller must display FLOOR
•Platform lights must still be illuminated
11. Make sure platform cannot be folded if occupied. Place a 50 pound weight on the platform, on the end closest to the inboard rollstop. Press FOLD button on the hand pendant.
•Platform must not fold
•Controller must display OCCUPIED
Remove the 50 pound weight from the platform before proceeding to the next check.
12. Make sure Lift folds into the stowed position and platform lights turn off. Press FOLD button on the hand pendant until the Lift is in stowed position and stops folding.
•Controller must display FOLD
•Platform lights must be turned off
•Controller must display STOWED * when Lift is stowed
13. Turn the power switch on the Lift controller OFF and then ON again. Check and record CYCLE
COUNT ________ and LIFT COUNT ________ indicated on Lift controller. Both counters must indi-
cate one more count than recorded at the beginning of CHECKLIST.
Check manuals and decals supplied with the Lift:
14. All decals are correctly affixed to Lift and on the vehicle. Refer to the DECALS & DECALS PLACE- MENT section in this manual for decal placement location instructions.
15. Lift Operation Manual and Maintenance Schedule are inserted in the vehicle owners manual.
VEHICLE I.D. (VIN)# _______________________________________
WHEELCHAIR LIFT SERIAL# ________________________________
CHECKED BY & DATE: _____________________________________
MAXON LIFT CORP. 11921 SLAUSON AVE. SANTA FE SPRINGS, CA 90670 (562)
PATENTS PENDING | 60 |
