Maxon Telecom WL7-VERS. C Ground Cable Routed from Lift, Bolting Ground Cable To Vehicle Frame

7.Uncoil the ground cable from the bottom of the pump cover. Route the ground cable on the Lift through grommet in vehicle floor (FIG. 33-1A & 33-1B).

GROUND

CABLE

GROMMET

GROUND CABLE ROUTED FROM LIFT

NOTE: Clean the ground cableFIG. 33-1Aconnection point on the

frame down to bare metal.

Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

NOTE: If there is a grounding point on the frame, use it to connect ground cable. Skip step 8.

NOTE: Apply dielectric grease to all electrical connections.

8.Extend the ground cable to reach vehicle frame (FIG. 33-2). Con- nect to an existing grounding point if available. If necessary, drill a 13/32” (0.406”) hole in vehicle frame for bolting the ground cable terminal lug (FIG. 33-2).

9.Bolt the ground cable terminal lug to vehicle frame as shown in FIG. 33-2.

BARE

METAL

TERMINAL LUG

3/8”-16 X 1” LG.

CAP SCREW

VEHICLE

FRAME

GROUND	3/8”-16
	HEX NUT
CABLE

3/8” LOCK WASHER

BOLTING GROUND CABLE

TO VEHICLE FRAME

FIG. 33-2

11921 Slauson Ave. Santa Fe

33 PATENTS PENDING