AUDIBLE INDICATORS
When the MS7220 scanner is in operation, it provides audible feedback. These sounds indicate the status of the scanner. Eight settings are available for the tone of the beep (normal, 6 alternate tones and no tone). To change the tone, use the
One Beep
When the scanner first receives power, the green LED will turn on, the red LED will flash and the scanner will beep once. (The red LED will remain on for the duration of the beep.) The scanner is now ready to scan.
When the scanner successfully reads a bar code, the red LED will flash and the scanner beeps once (if programmed to do so). If the scanner does not beep once and the red light does not flash, then the bar code has not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes page 15.
Three Beeps - during operation
When placing the scanner in program mode, the red LED will flash while the scanner simultaneously beeps three times. The red and green LEDs will continue to flash until the unit exits program mode. Upon exiting program mode, the scanner will beep three times and the red LED will stop flashing.
When configured, 3 beeps can also indicate a communications timeout during normal scanning mode.
When using
Three beeps will also occur during a manual adjustment of the beeper tone. With each short depression of the
Three Beeps - on power up
This is a failure indicator. Refer to failure modes page 15.
15
