MICROBOARDS TECHNOLOGY, LLC HCL Series
17
Processing...
Please Wait
Loader Processing
Drive 1 <- Input Bin
Input Bin Empty (20)
Press OK to Continue
Loading... RESERVED
36% 121MB Loaded
Loader Processing
Drive 1 -> Output Bin
Master #1, Total 20
Pass 20, Fail 0
Master #2, Total 40
Pass 40, Fail 0
Master #3, Total 30
Pass 30, Fail 0
Access Log File
OK?
The loader will continue to remove discs from the Input Spindle and place those into drives until either all of
the drives are full or all Input Spindles are empty.
It takes a few seconds for the autoloader to recognize all of the discs in the
trays.
Once all of the discs are detected, the autoloader will detect the master disc
and read the contents of the master disc into the reserve partition.
Once the master disc has been loaded, the autoloader will remove the
master disc from the drive and place it onto the Output Spindle.
The loader will then pick up another blank disc and load it into the drive
where the last master disc was placed.
Once the loading process is completed, the duplication process will start. When the duplication process is
through, the loader will remove the discs from the drives and place successful copies onto the Output
Spindles and place failed copies into the Reject Area.
In Multi Master Mode, the robotic arm continues to load more media into the drives from Input Spindles while
the duplicated discs are placed in the Output Spindle. Once a new Master disc are been detected by any of
the drives, this process will repeat for the new Master disc.
When all of the jobs are complete, and the autoloader detects all Input Spindles are empty, it presents you
with the Input Bin Empty message:
Press the OK button to continue and you will see the Access Log File
screen:
Press the OK button to view the log file or press the ESC button to
return to the 1.Copy menu. If you choose to see the log file, you will see a
screen similar to below:
Use the Up or Down buttons to look at the log file for the various jobs.
Press the ESC button to return to the 1.Copy menu
2. Test
Use the Test menu or Test quick key to simulate the copy process. With simulation, write once recordable
discs such as DVD-R, or CDR will be reusable. The purpose of simulation is to ensure error free duplication.
Note: Due to physical limitations of the DVD+R recordable format, if you try to simulate DVD+R
copying, you will encounter failure messages.
Warning: If you are using CD/DVD Rewritable discs as your media during the simulation, the content
on those discs will be permanently erased.
Operation in Test mode is identical to operation in Copy mode. See Copy on page 14 for instructions.