MICROBOARDS TECHNOLOGY, LLC | HCL Series |
4. Test+Copy
With the Test + Copy menu option, the autoloader simulates the copying process, and then makes copies if everything works correctly. If a failure is encountered on a disc during the simulation, it will not be copied during the copying process while the discs that passed the simulation will move on to the copying process. After the copying process, the autoloader will place the failure discs into the reject area while the successfully copied discs will be placed into the corresponding Output Spindle.
Operation in Test+Copy menu is identical to operation in Copy menu.
5. Copy+Compare
The Copy + Compare menu option is used to make verified copies. After the copy process is done, the autoloader automatically compares the copies to the master content residing in the hard drive to ensure that they are identical. When the operation is complete, the autoloader automatically places good discs on to the Output Spindle and bad discs in the Reject Area.
Operation in Copy+Compare menu is identical to operation in Copy menu.
6. Select Burn Speed
The Select Burn Speed menu option is used to adjust the duplication speed for the various duplication modes. By default, the duplication speed will be set to the optimal speed. However, under some circumstances you might want to lower the duplication speed. Those circumstances are:
¾Poor Blank Media Quality - When your media quality is
¾Duplication Quality - Overall, the lower the speed, the higher the quality of your duplicates. If you have time, it is a good choice to lower the speed to produce the best quality duplicates.
If you are at the 1. Copy Menu, do the following:
Use the 
Up or 
Down button to find the 6. Select Burn Speed menu.
Press the 
OK button on 6. Select Burn Speed menu to set the duplication burn speed and you will see the Select Burn Speed type menu similar to below:
There are two recording speed types that can be set:
¾ HDD to CD: Copy Hard Drive CD Content to
¾HDD to DVD: Copy Hard Drive DVD Content to DVD±R/RW Discs.
Depending upon the type of duplication and your autoloader restrictions, you need to select the correct format in order to take effect. To select the recording speed options, use the 
Up or 
Down buttons to find the desired speed for the appropriate format and press the 
OK button to enter the menu. You will see a menu similar to this:
HDD to CD Speed 32x
Use the 
Up or 
Down button to find the desired speed. Press the 
OK button to set the desired recording speed.
The options that are available are shown in Table
Duplication Type | Speeds Available | ||
|
|
|
|
HDD | to | CD | 1x, 2x, 4x, 8x, 12x, 16x, 24x, 32x, 40x, 48x, |
Speed |
|
| 52x |
HDD | to | DVD | 1x, 2x, 2.4x, 4x, 6x, 8x, 12x, 16x |
Speed |
|
| |
|
|
| |
Table 2-1 Duplication Speeds
These options might change depending on the CD or DVD writers
Note: The speed that you choose may be adjusted by the drives and/or the media for optimized duplication.
19
