Open debug message will show up specific information while VoIP FXO gateway is in operation. After executing the debug command, it should execute command debug -openas well. One example is demonstrated below.

usr/config$ debug -add h323 vp usr/config$ debug -open

Parameters Usage:

-status

Display the enabled debug flags.

-add

Add debug flag.

 

-- h323 : h323 related information

 

-- vp : voice related information

-delete

Remove specified debug flag.

-open

Start to show debug messages.

-close

Stop showing debug messages.

5.4 [reboot] command

After commit command, type reboot to reload VoIP FXO gateway in new configuration. The procedure is as below:

usr/config$ reboot

Attached TCP/IP interface to cpm unit 0 Attaching interface lo0...done AC4804[0] is OK

AC4804[1] is OK AC4804[2] is OK Successful

Initialize OSS libraries...OK! open stack successful cmInitialize succeed!

GK mode selected.

login:

5.5 [flash] command

This command will clean the configuration stored in the flash rom and reboot VoIP FXO gateway in factory default setting.

Parameter Usage:

-clean clean all the user-defined value, and reboot VoIP FXO gateway in factory default mode.

Note:

It is recommended that use “flash –clean” after application firmware id upgraded.

19

Page 19
Image 19
MicroNet Technology SP5052, SP5050 Reboot command, Flash command, Usr/config$ debug -add h323 vp usr/config$ debug -open