![Venting the dispensing system:](/images/new-backgrounds/65543/6554377x1.webp)
Programming special functions
4.Venting and setting the dosage on “DOS module G 60 or C 60” (special version)
Set the dosage selector on the DOS module to the “10” position (on DOS module C 60 only).
Turn the programme selector to the
f“STOP” position.
Switch off the machine.
Press 4 and 6 at the same time, hold them in and whilst doing so switch the machine on with the
The current programme status “P...” appears in the display.
The p / 6 indicator light comes on.
Press 3 twice, “E02” (programming level 2) appears in the display.
Venting the dispensing system:
Turn the programme selector to the
pposition. “do1” appears in the dis- play.
Press 4 for 90 seconds.
The dispensing system is vented.
If only venting is required:
Switch the machine off with the
Immediately after this: start the D (COLD) programme, so that after vent- ing any agents in the wash cabinet are diluted before being drained away.
Setting the dosage:
Set the amount to dispense according to the detergent manufacturer’s recom- mendations.
The machine needs 7 litres of water in the “Main wash” programme stage.
Example:
The detergent manufacturer recom- mends 4 ml cleaning agent per litre of water.
7 l x 4 ml/l = 28 ml.
2 ml . 1 sec. dispensing time; i.e. pro- gramming to 14 secs.
Turn the programme selector to the
qposition, the dispensing time in seconds appears in the display, e.g “10”.
Press 4 repeatedly or hold it in, until the number “14” appears in the display (dispensing time 14 seconds
. 28 ml - see example).
The dispensing time/amount is set.
Having changed a value or all values:
Press 6. “SP” appears in the display.
Press 6 again. The change has been recorded.
Value set:
If the dispensing system also needs to be vented:
Start the D (DRAIN) programme, so that after venting any agents in the wash cabinet are diluted before being drained away.
35