Correcting minor faults
Water in the wash cabinet is not heated; the programme sequence lasts too long
This machine has a resettable thermal cutont which will switch off the heaters in the case of overheating. This could be caused, for example, if large articles cover the heating elements or if the fil- ters in the wash cabinet are blocked.
Remove the cause of the fault.
Take off the service panel (see “Elec- trical connection”).
Press the reset button on the heater limiter (yellow) located on the left hand side of the plastic cover.
If this switch trips again, the Miele Service Dept. must be contacted.
After Sales Service
Should you still have any difficulties or if the fault code “F...” shows in the dis- play field please contact your auth- orised Service Dealer or the Miele Ser- vice Department.
See back cover for addresses.
Please quote the fault code “F...” as well as the model type and number of your machine.
This information can be found on the data plate inside the door (see also “Electrical connection”).
Please note that telephone calls may be monitored and recorded to improve our service.
43
