Problem solving guide
. . . "dn" appears in the temperature display.
The demonstration function is activated.
^Call the Service Department.
. . . you cannot switch the ice cube maker on.
^Check whether the appliance is connected to the electricity supply.
. . . the ice cube maker is not producing any ice cubes.
^Was the water inlet pipe purged of air by a qualified and competent person before the appliance was used for the first time?
^Check whether the ice cube maker is switched on.
^Check whether the freezer section is switched on.
^Check whether the water inlet is open.
^Check that the ice cube drawer has been closed properly.
It can take up to 24 hours to produce the first ice cubes.
. . . the ice cube maker is only producing small ice cubes.
The size of ice cubes which are produced over a certain period of time will depend on the water pressure present.
If the ice cube maker is only producing small ice cubes, the water pressure is low.
^Lengthen the water intake time for the ice cube maker (see "Making ice cubes").
. . . the indicator light on the ice cube maker flashes.
The ice cube tray is in its cleaning position (see "Cleaning and care").
If this is not the case, then there is a fault.
^Call the Service Department.
. . . you cannot switch the appliance off.
The safety lock has been activated.
. . . the interior lighting in the refrigerator section is not working.
^Was the door left open for too long? The lighting switches itself off automatically after approx. 15 minutes if the door is left open.
If this is not the case, then the interior lighting is defective.
^Disconnect the appliance from the mains. Switch off at the wall and withdraw the plug from the socket, or disconnect the mains fuse or remove the
49
