Miller Electric 350, 350P, Millermatic 350 Volt-Ampere Curve, Connecting To Weld Output Terminals

.A complete Parts List is available at www.MillerWelds.com

3-3. Volt-Ampere Curve

MAXVOLTS

MINVOLTS

	90
	80
	70
	60
VOLTAGE	50
	40
	30
	20
	10
	0
	0	50	100	150	200	250	300	350
				AMPERAGE

1 Normal Volt-Ampere Curves

The volt-ampere curves show the normal minimum and maximum voltage and amperage output capabilities of the welding power source. Curves of other settings fall between the curves shown.

217 443-A

3-4. Connecting To Weld Output Terminals

4

	1
			Do not place
			anything between
			weld cable terminal
			and copper bar.
	2
Tools Needed:	3
3/4 in (19 mm)
		Correct Installation
! Turn off power before connecting to		1	Weld Output Terminal
weld output terminals.		2	Supplied Weld Output Terminal Nut
! Failure to properly connect weld		3	Weld Cable Terminal
cables may cause excessive heat		4	Copper Bar
and start a fire, or damage your ma-		Remove supplied nut from weld output ter-
chine.		minal. Slide weld cable terminal onto weld

803 778-A

Incorrect Installation

output terminal and secure with nut so that weld cable terminal is tight against copper bar. Do not place anything between weld cable terminal and copper bar. Make sure that the surfaces of the weld cable terminal and copper bar are clean.

OM-1327 Page 12