.A complete Parts List is available at www.MillerWelds.com

5-4. Arc Times, Arc Starts, Hot Start (Aluminum Pulse Only), And Crater Fill

.Accessing the Arc Times, Arc Starts, Hot Start (aluminum pulse only), and

Crater Fill data will also allow access to Software Version data and Motor Calibration function. The software version data and motor calibration func- tion are for use by factory authorized service personnel only.

Do not use the motor calibration function if it appears on the displays.

2

1

3

4

Ref. 213 935-A

 

 

Arc times and number of arc starts are saved in unit memory. To view this information, press both SETUP (1) and ARC CONTROL (2) buttons at the same time.

Left display will initially show arc hours.

Rotate left knob (3) and display will change to show number of arc starts.

To turn on the Crater Fill display, rotate left knob (3) until CRTR appears in the left display. The factory default for Crater Fill display is OFF which appears in the right

display. Rotate the right knob (4) until ON appears in the display.

.The Crater Fill display can be turned

off after parameters are set in pro- grams, but remember that once crater fill is turned on in any program, it will remain on even though it does not ap- pear in the displays because Crater Fill display is turned off.

To exit this menu, press either the SETUP

(1)or ARC CONTROL (2) button, or press a gun trigger on any welding gun connected to the unit.

OM-1327 Page 33

Page 37
Image 37
Miller Electric Millermatic 350, 350, 350P manual Crater Fill display can be turned