.A complete Parts List is available at www.MillerWelds.com
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Drive Roll
5 Intermediate Wire Guide
76 Outlet Wire Guide
7 Pressure Adjustment Knob
8 Gun Conduit Cable Lay gun cable out straight.
8 | Tools Needed: |
1 | 2 | 3 | 4 | 5 | 6 |
IMPORTANT!
For Aluminum Push−Pull welding. Thread hub tension nut loosely
.Hold wire tightly to keep it from unraveling.
6 in (150 mm)
218243−A
Open pressure assembly.
Tighten
1
2
3
4
Push wire thru guides into gun;
continue to hold wire.
Close and tighten pressure assembly, and let go of wire.
Pull and hold wire; cut off end.
IMPORTANT!
For Aluminum
Push−Pull welding.
Pressure4321
Indicator
Scale
218244−A
.Use pressure indicator scale to
set front drive roll pressure to 1 and rear drive roll pressure to less than 1.
See Section
Ref. 803
