Mitsubishi Electronics L75-A94 First-Time Power-On, Setting Up and Using TV Inputs, Home Retail

1. Basic Setup and Operation 9

First-Time Power-On

1.Install batteries in the remote control. See page 5.

2. Aim the emitter (bulb) end of the remote control at the TV and press the POWER key . Wait for the Welcome screen.

3.If you wish to change the menu language to Español, press and press ENTER.

4.Press to move to the energy-mode selections. Select Home.

5.Press to highlight EXIT. Press ENTER to clear the menu.

Welcome Screen Energy Options

•Mitsubishi recommends the Home setting, which uses power within ENERGY STAR® guidelines.

•The Retail setting looks best under the bright lighting often found in commercial settings. In this mode, the TV uses power in excess of ENERGY STAR guidelines.

This table compares energy choices offered in the Welcome screen.

	Home	Retail
Picture Mode	Bright	Super Brilliant
Ambient Light	Maximum	Off
Sensor Sensitivity

Use the Picture > Video menu to change the Picture Mode. Use the Setup > Energy menu to control sensitivity of the Ambient Light Sensor.

Setting Up and Using TV Inputs

The ANT (Antenna) Input

If using an antenna or direct cable service (no cable box), connect the incoming coaxial cable to the TV’s ANT input. Refer to page 16.

You must perform a channel scan to enable recep- tion of digital channels. If you skip this step, the TV can receive only analog channels. The channel scan will search for high-definition and standard-definition channels available in your area. Note: Direct cable service will not include scrambled or premium chan- nels.

Memorizing Channels with Channel Scan

1.Power on the TV.

2.Press MENU and open the Setup > Channel menu.

Start channel memorization from the Setup > Channel menu.

3.Press to enter the menu.

4.Highlight Ant Air if connected to an over-the-air antenna. Highlight Ant Cable for service over direct cable (no cable box). Press ENTER to add a check.

5.Select the scan type.

•For first-time setup, highlight All channels.

•To scan for channels not already in memory, highlight Add only new channels. Press ENTER to add a check.

6.Highlight Scan and press ENTER. Channel memorization may take up to 15 minutes to complete.

To stop channel memorization before completion, press CANCEL.

At any time after Channel Scan,

•Use the Setup > Channel > Edit menu to add or delete individual channels to or from memory.

•Repeat the All channels scan if you reposition the antenna or move the TV to a new geographic area with a different channel line-up.

For assistance call 1(877) 675-2224