Mitsubishi Electronics PEH-15MYA, PE-8MYC manual HOW to Operate Option PAC-204RC, Display section

HOW TO OPERATE (OPTION PAC-204RC)

Display section

C G B

H

D F

A

E

A [Current/start/ending time] Display

BOperation mode

Displays the status of operation.

C [Checking] Display

This displays indication when some abnormality occurs in the unit.

D[Set temperature] Display Displays the set temperature.

E[Operation] Lamp

Lights up during operation, goes off during stop.

F[Room temperature] Display

Displays the temperature of the air sucked in during operation.

G[Fan speed] Display

This displays indication High-speed or Low-speed.

H[Key lock] Display

This display indication during key lock function active.

For purposes of explanation, all the displays on this page are shown in their lit condition. This configuration does not occur in the actual unit.

Before starting operation

*Make sure that the power supply is turned ON before use. (Keep the power supply turned ON at all times when the air conditioner is in use. Use of the unit without power can result in compressor failure.)

Warning:

Check and confirm the power circuit before use. For the contents, refer to the previously described chapter [Crucial points to be observedfor safety].

1-1 ON / OFF

A

Start an operation

Press the [ON/OFF] button

Operation lamp lights up and operation starts.

1

Stop an operation

Press the [ON/OFF] button again Operation lamp goes off and operation stops.

* Once the buttons have been set, pressing of the [ON/OFF] button only can repeat the same operation thereafter.

* During operation, the operation lamp above the [ON/OFF] button lights up.

AOperation lamp

Caution:

Even if the operation button is pressed immediately after the operation is once stopped, operation is not restarted for about 3 minutes. This function protects the machine. It automatically starts operation after the lapse of approximately 3 minutes.

- 108 -