MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927

3. Adjustment Selection

Use the “VIDEO” button to select a specific electrical ajustment, “1 HPOS” or “2 VPOS”.

4. Adjusting Data

After selecting an adjustment item, use the “UP” and “DN” buttons to change adjustment data.

ªIf the “UP” button is pressed, the adjustment data increases.

ªIf the “DN” button is pressed, the adjustment data decreases.

5.Saving data

Press “ENTER” to save the adjustment data in memory.

The display characters go red for approx. one second in this step.

Note: If the circuit adjustment mode is terminated without pressing “ENTER”, changes in adjustment data are not saved.

6. Terminating the circuit adjustment mode

Press the “MENU” button on the remote hand unit twice to terminate the adjustment mode.

Note: The adjustment mode can be also terminated by turning the power off.

Resetting Data to Factory Values

1)Enter the Service Adjustment Mode ... Press “MENU-2-4-5-7”

2)Press “0” when in the Service Mode ... Three choices appear at the top of the screen.

Data Transfer

MENU-2-4-5-7-0

Display

Description

Copy Engine E2PROM to DM

Transfers Engine data to DM E2PROM

Restore Backup

Restores data to factory values

UPLOAD TERMINAL BOARD DATA

DO NOT USE

Download WB Alignment to FMT

Transfers Engine data to FMT

3) User UP & DN keys to highlight the desired choice, the Press “ENTER”

Page 41

Page 41
Image 41
Mitsubishi Electronics V30+, V29 Resetting Data to Factory Values, Adjustment Selection, Adjusting Data, Saving data