EN-15
5. Operation of projector

5.2. Confirmation of projector status

The status of the projector is displayed on the projector list on the main scree n.
Item Description
Check Theftdetectorsetting(ON/OFF)
No. Projector list registratio n number
Projector Name Projector name set in the application
MAC Address MAC address of the projec tor
IP Address IP address of the projector
Power Powersupplystatusoftheprojector(ON/OFF)
Input Source *1 Inputsignaloftheprojector(COMPUTER1/COMPUTER2/VIDEO/S-VIDEO/
HDMI(HDMI1/HDMI2)/DVI-D/SDI/PCLessPresentation/USBDisplay/LAN Display/
COMPONENT)
AVMute Mutestatusoftheprojector(ON/OFF)
Lamp1/2Time(Low) Lampilluminatingtime(HHHH:MM)
In the case of the projector equipped with two lamps, illuminating time for
the lamp 1 is displayed in the left side and illuminating time for the lamp 2 is
displayed in the right side.
Group Name The belonging group of projector
*1 HDMI a nd DVI-D are displayed with DIGITAL 1 or DIGITAL 2 by a connected projector.
• Theprojectorstatusisre-obtained(refreshed )automaticallyandperiodically,butthepresentstatuscan
also be obtained by the user’s instruction. When clicking [Refresh Status] of the tool bar o n the main screen,
Power,InputSource,AVMute,andLamp1/2Time(Low)statusofeachprojectorisre-obtained.
• ThestatusofInputSourceandAVMutewillnotbeobtainedunderthefollowingconditions:
- when the projector is powered off
- during warm-up or cool-down.
• Whenclickingthestatustagoftheprojectorlist(excepttheMACaddress),thelistcanberearrange d(sorted).
The list can be rearranged in reversed order by pres sing one more time.
• Whenclicking[SelectAll]ofthetoolbar,allprojectorsintheprojectorlistbeco meselected/nonselected
state.
• Ifanyabnormalstateoftheprojectorisdetectedbyacquiringtheprojectorstatus ,anerrormessagewillbe
displayed on the error message display column at the lower part of the sc reen.
<Note>
• Thedefaultcycleoftheautomaticre-acquisitionis10minutes.Tochangethiscycle,see“3.1.System
set ting s.”
• Whenmultipleprojectorsareconnected,itmaytaketimetoacquirethestatus.Du ringacquiringthestatus,
the status bar at the lower part of the main screen become s “Getting status...”, and it becomes “Done” when
the acquisition has been completed.