ELECTRICAL INSTALLATION | HBDV7 Series Direct Vent Gas Fireplace |
Remote Wall mounted Switch
A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. Attach the wall switch in a junction box at the desired location on the wall. Figure 45. Do not extend beyond the wall switch wire length provided.
NOTE: Extended lengths of wire may cause the fireplace not to function properly. Longer length of wire is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local code.
Gray
PILOT |
| HI |
OFF | ON | TH |
|
| |
|
| TP |
|
| TH/TP |
WARNING | Do not connect wall switch to (110 V) |
| |
| circuit. |
|
|
|
|
| White |
|
|
| Black |
|
| Blue | OPTIONAL REMOTE |
|
|
| |
|
|
| WALL SWITCH |
|
|
| ON |
ON | OFF | RS | OFF |
|
| ||
|
|
|
Figure 45 - |
|
|
|
|
|
|
Wiring Diagram for Wall Switch | Black | OPTIONAL REMOTE | ||||
| WALL SWITCH | |||||
|
| |||||
Remote Wall Switch | Blue |
|
|
|
| ON |
| ||||||
Black |
|
|
|
| OFF | |
|
|
|
| |||
Position the wall switch. Do not extend beyond the 15 feet of wire. |
|
|
|
|
| |
|
|
|
|
| ||
|
|
|
|
|
| |
Optional DC Remote Systems
These instructions replace the section entitled Hearth Mount in the Millivolt hand held remote instruc- tions supplied with the remote.
1.Plug in remote connector wire to remote receiver.
2.Connect the wire terminal from the remote receiver. This replaces the 15' wall switch connection to the switch. Figure 46
3.Mount remote control receiver at junction box (for your wall switch).
Optional Fan/Blower Systems
The junction box for the fan/blower systems has been factory installed. This system requires that 110- 120V AC to be wired to the factory installed junction box before the fireplace is permanently installed. Figure 46
120VAC
Receptacle
Junction
Box
BLACK
GREEN
BLACK | BLACK | WHITE BLACK | BLACK | ||
Figure 46 - | Speed Control |
|
| ||
Blower Wiring Diagram | Optional Thermostatic Switch | ||||
|
| ||||
54D8000 | 27 |
