Monessen Hearth KHLDV400 Touch Screen Remote Control Operation, KHLDV Series Gas Fireplace

TOUCH SCREEN REMOTE CONTROL OPERATION KHLDV Series Gas Fireplace

	Due to the sensitive temperature monitoring
	components in the transmitter, it is necessary
NOTE	to allow the transmitter to stabilize to room tem-
	perature before accurate room temperatures
	are displayed. If the transmitter is activated
	from a severe cold condition, allow 15 minutes
	for accurate temperature readings to appear on
	the LCD display.
WARNING	Turn appliance OFF (at the Master Switch) if
	you are away from your house for an extended
	period of time. Never leave anything on top of
	the surface of the transmitter.

nFunction Areas of the LCD Display

Figure 26 shows the display of the TSFRSC LCD.

Information Bar

The information bar shows the room temperature, the “sending signal” radio icon, the low battery indication icon,

Information Bar
	Menus
Touch Area	Adjustment Controls
Logo Bar
	Function Areas of the LCD Display
Logo Bar	Figure 49

The Logo Bar contains the brand logo: Signature Com- mand System.

the child-proof icon, and the flame icon. This area doesn’t have touch buttons.

•The room temperature will always be shown after power-up. It displays the room temperature from 40 °F to 99 °F. “Lo” and “HI” will be displayed when the room temperature is lower than 40°F or higher than 99°F, respectively.

•The radio icon will be shown when the transmitter is sending a signal.

•The low battery indication icon will be shown when the battery voltage is low.

•The child-proof icon will be shown when the child- proof mode is activated.

•The flame icon indicates the current flame height - Off, Low, Medium and High

nInitialization and Setting up

Installing Batteries:

Figure 50

The remote transmitter has two battery compartments, one on each end of the trans- mitter. Always change all four (4) batteries at the same time.

To install batteries,

1.Press down the battery door tab and pull out to re- move the battery door.

2.Install the batteries as in- dicated inside the battery compartments.

Battery Door Tabs

Figure 50

Touch Area

The touch area contains all touch buttons to control the transmitter. It consists of two categories: menus and ad- justment arrows. The blue LED backlight lights up for 8 seconds when any of the touch buttons is pressed.

•The menus include TIMER, THERMO, LIGHT, FAN and AUX (Rear Burner Control).

•The adjustment arrows include ON/up and OFF/ down. Their default function is to adjust the flame height. When a button from the menu is pressed, the ON/up and OFF/down buttons will temporarily become adjustment controls for the selected item. When the adjustment is done, the ON/up and OFF/ down buttons go back to flame height controller again.

3.Close the battery door by snapping in place.

4.When all four batteries are installed, the transmitter will initialize for 5 seconds and then is ready for use.

5.The batteries should be replaced every 12 months or when the low battery icon indicator is displayed.

Changing Temperature Unit

When batteries are installed in the transmitter,

1.All available icons on the LCD will be turned on then be cleared.

2.The LCD will display temperature unit: °F. Use ON ∆ to toggle the units between °F and °C within the first 5 seconds.

3.The transmitter enters Manual Mode

4.The LCD displays room temperature with the chosen unit.

73D0024 39