TOUCH SCREEN REMOTE CONTROL OPERATION | KHLDV Series Gas Fireplace |
1.Press the ON/up button to turn on the fireplace. The flame icon on the LCD displays
High.
2.Press the OFF/down button to decrease the flame height and turn off the fireplace. When the OFF/down button is pressed for three times, the flame icon changes form High to Medium, to Low, then to Off.
3.If the OFF button is held for more than 3 seconds at any flame height, the fireplace will be turned off and the flame icon disappears.
4. Sliding up and down on the ar-
row buttons can also turn on or turn off the fireplace.
5.If the fireplace is shut off using the above methods in 3 and 4, all the settings will be remembered and will be resumed next time the fireplace is turned on (Memory Off).
Timer Mode
Figure 55
Press the TIMER button to enter timer mode. The fireplace will stay on for a period of time as specified by the timer and then be shut off by the transmitter when the timer counts down to zero.
1.When the TIMER button is pressed, the Set Time appears in the frame of the button and flashes.
2.Use ON/up and OFF/down to
increase or decrease the Set
Time in 15 min. increments, between 0:00 to 6:00. Sliding up and down on the arrow buttons will increase
c. Slide down on the arrow buttons to exit TIMER mode and shut off the fireplace.
Thermostat Mode
Figure 56
Press the THERMO button to set the transmitter in thermostat mode. The transmitter will au- tomatically turn on the fireplace when the room temperature is below the set temperature and turn off the appliance when the room temperature is above the set temperature within one de- gree.
1. When the THERMO button is
pressed, the Set temperature | Figure 56 | |
appears in the frame of the | ||
| ||
button and flashes. |
|
2.Use ON/up and OFF/down to increase or decrease the Set temperature in 1 degree increments, between 45 degrees and 90 degrees. Slide up and down on the arrow buttons will increase or decrease the Set Tem- perature in 10 degrees increments.
3.Press the THERMO button again to confirm the Set Temperature. The transmitter will send out an On signal or an Off signal depending on the relationship between the Set temperature and the Room tempera- ture.
4.The flashing stops and the ON/up and OFF/down but- tons become flame height controller again. The flame height will then stay as set up by the ON/up and OFF/ down buttons.
5.To exit Thermostat Mode:
a.push and hold the THERMO buttons for 3 sec- onds or
b.slide down on the arrow buttons to exit Thermo- stat mode and shut off the fireplace.
or decrease the Set Time in 1 hour increments.
3.Push the TIMER button again to confirm the Set Time, the transmitter sends an ON signal to turn on the fire- place.
4.The flashing stops and the ON/up and OFF/down but- tons become flame height controller again. The flame height will then stay as set up by the ON/up and OFF/ down buttons.
5.The TIMER button can be used when the transmit- ter is in Manual Mode or in Thermostat Mode. In both modes, the fireplace will be shut down completely when the timer counts down to zero.
6.To exit Timer Mode,
a.Push and hold the TIMER button for 3 seconds Or
b.Use the OFF/down buttons to decrease the Set Time to zero Or
Smart Mode Option for Thermostat Mode Figure 57
Press and hold the THER- MO button and the ON/UP button at the same time for 3 seconds to toggle be- tween Smart Mode and the regular Thermostat Mode. The icon “Smart Mode” will appear under the Set Tem- perature. The transmitter will automatically adjust the flame height according to the difference between the Set temperature and the Room temperature. There
Smart
Mode
Icon
Figure 57
73D0024 | 41 |
