Monessen Hearth KHLDV500 n Using the Mounting Base, KHLDV Series Gas Fireplace, Symptom, causes

KHLDV Series Gas Fireplace TOUCH SCREEN REMOTE CONTROL OPERATION

n Using the Mounting Base

The transmitter comes with a mounting base which allows you to hang the transmitter on the wall.

1. Secure the mounting base on the wall with supplied screws. For best viewing angle, make it the same height as your eyes.

2. Hang the transmitter on the hook of the mounting base, then push down so the transmitter is flush to the

mounting base. Figure 62

TROUBLESHOOTING

Symptom	causes		action
1. Battery icon on LCD on transmitter	1. Low Battery	1.	Replace batteries. Change batteries
			every 6 months.
2. LCD display is blank		2.	Check battery installation or replace
			batteries.
3. LCD display shows “funny” display		3.	Reset the transmitter (see “Resetting
			the Transmitter” section).
4. Appliance does not come on	2. The transmitter did not match	1.	Make sure the transmitter has
	with the receiver		learned to the receiver.
	3. Transmitter measures temp-	1.	Move transmitter to a cooler place
	erature exceeding 99 degrees		and wait until temperature drops
	Fahrenheit and shows “HI” on		below 99 degrees.
	LCD
	4. Distance between the transmitter	1.	Make sure the opening distance is
	and receiver is more than 30 feet		less than 30 feet.
5. Blower is not on after the fireplace is	5. Blower setting is off	1.	Press FAN key to select Fan speed
turned on			you desire.
	6. Blower delay setting is set too	1.	Press and hold FAN key to set
	high		desired ON/OFF delays. This is done
			in minutes.

44 73D0024