Motorola MTH800 manual Receiving a Group Call, TMO Group

The “No Group” message is displayed when you are out of the normal coverage area of your selected group. You must then select a new group that is valid for your working location.

Receiving a Group Call

General

Unless it is engaged in a call, your MTH800 will receive the Group Call.To answer the call, press and hold PTT.

Your MTH800 shows the Group name and the caller’s private number or name if previously stored in your contact list.

The following screens show examples of how the caller’s private number (ID 124) is displayed.

Group In Use
ID:124
TG4
Optns	Folder

Private ID without alias

	Group In Use
OR	Folder 1
	TG4
	Optns	Folder

Private ID with alias

TMO Group

For incoming call alert, see settings in the Vibrate menu option (page 81) and the Tones menu option (page 85).

Any incoming Group call is ALWAYS received through the main speaker. If configured by your Service Provider, the Group Audio menu item allows to setup the audio of the incoming Group Call.

If the setup is Speaker Control, you can direct the audio of an active group to the earpiece (low audio) or the main speaker (high audio). In low audio speak into the bottom microphone and listen via the earpiece. In high audio speak into the top microphone and listen via the speaker.

At the end of a call which has been directed to the earpiece, an audio hang timer is activated, if it is enabled by your Service Provider. Within the preprogrammed hang time, any incoming call is still received through the earpiece. When the timer expires, a low pitch tone is emitted alerting you that the next incoming Group call will be received through the speaker. Upon hearing this alert, you are advised to hold the terminal at a comfortable distance away from the speaker.

Call

37