46 | MTM5400 Mobile Terminal Installation Manual | INSTALLATION |
|
|
|
8.Verify that the antenna cable is routed in the shortest way to minimize power loss over the cable.
9.Check that the mounting surfaces are able to support the weight of the units.
If an additional GPS antenna or a combined TETRA/GPS antenna is used, the antenna housing carries the GPS receiver. Take care not to cover the antenna housing with metal or other radio wave absorbing material.
MOTOCYCLE MOUNT ENHANCED CONTROL HEAD
P/N: PMKN4030
TRANSCEIVER |
| ||
| LOUDSPEAKER | FIST MICROPHONE CABLE | |
BATTERY | P/N: PMKN4029 | ||
|
| use with the Mic or Handset | |
FUSE |
| FIST MICROPHONE | |
|
|
| |
BLOCK |
|
|
|
|
|
|
|
|
|
|
|
MOTORCYCLE BOX
ANTENNA
CHASSIS GROUND
FUSED POWER CABLE
P/N: GKN6270 (3m, FUSE 10A)
Figure 16 Motorcycle Installation
Installing the Motorcycle Mount Enhanced Control Head
1.Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps into place.
2.Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount Enhanced Control Head for an optimum view of the display. Then, complete the tightening of the screws.
3.There are two ways to mount the motorcycle trunnion, each limited to a 77 degree of allowable movement, as shown in Figure 17 and Figure 18:
