INSTALLATIONMTM5400 Mobile Terminal Installation Manual63
|
| Table 10 |
|
|
|
Pin | Function | Description |
|
|
|
1 | Audio + | Balanced Audio + (Bidirectional) |
|
|
|
2 | Not Connected |
|
|
|
|
3 | BUS+ | This is used for communication between the radio and an Enhanced Control Head. |
|
|
|
4 | Audio- | Balanced Audio - (Bidirectional) |
|
|
|
5 | Not Connected |
|
|
|
|
6 | Ground | Ground |
|
|
|
7 | Radio On/Off Control | This is the Enhanced Control Head service request input. A level of 5 volts |
|
| indicates that the Enhanced Control Head needs to communicate with the radio. In |
|
| addition it switches on the radio's voltage regulators. The idle state is a level below |
|
| 0.6V. |
|
|
|
8 | SCI_TX | This if for communication between the radio and the Enhanced Control Head. |
|
|
|
9 | FLT_A+ | This voltage is at battery voltage level and is available as long as the radio is |
|
| connected to the supply voltage. The maximum current is 300mA. A fuse in the |
|
| radio prevents further circuit damage in case of shorting this pin to ground. |
|
|
|
10 | Analog Ground | Analog Ground |
|
|
|
25-Pin subD Connector
Data Expansion Head Enhanced:
|
| Table 11 |
|
|
|
Pin | Function | Description |
|
|
|
1 | GND | Ground |
|
|
|
2 | RS232_SCI_TX | Transceive data (RS232 line with RS232 level) |
|
|
|
3 | RS232_SCI_RX | Receive data (RS232 line with RS232 level) |
|
|
|
4 | RS232_RTS | Request to Send (RS232 line with RS232 level) |
|
|
|
5 | RS232_CTS | Clear to Send (RS232 line with RS232 level) |
|
|
|
6 | FLT_A+ | Filtered unswitched UB+ / 200mA |
|
|
|
7 | Signal_GND | Ground for RS232 |
|
|
|
9 | NC | Not Connected |
|
|
|
10 | NC | Not Connected |
|
|
|
11 | NC | Not Connected |
|
|
|
12 | SW_B+ | Switched UB +/100mA |
|
|
|
13 |
|
|
|
|
|
