Motorola r750plus manual Sending a Status Message, Exiting the Status Message Function

Advanced Features

Sending a Status Message

After selecting both a Status Message and a desired target ID, press the PTT button to send the message. Two high pitched tones will be heard during transmission.

If successful, two high pitched tones will be heard to indicate the message was successfully delivered to the target portable.

If unsuccessful, an alert tone will be heard to indicate that the targeted unit is busy, out-of-range, or turned-off.

In either case, the portable will return to the status screen after 3 seconds.

a b

Sts-Sent

Successful

a b

User Not

Available

Exiting the Status Message Function

Press the mkey to exit the Status Message screen. Pressing the “Exit” option key from the Status Message screen will also allow you to exit the status message function.

Receiving a Status Message

The portable will receive a message along with alert tones. To silence the recurring alert tones only, press any key except mor the “Clear” option key. In case of a non-aliased sender ID, the Quickstore option is available.

If a non-aliased ID is sent, the Quickstore softkey is displayed.

All calls remain blocked until this message is cleared.

a b

Sts-Kelly

At Lunch

Clear

ID List Programming

Feature menu #26 allows you to program ten status messages, each up to 12 characters long.

a b

26=Sts Mesg List Program

Exit Ok

41