MRV Communications LX-4000 Series manual Environmental and Installation Considerations, Mbps

Installing the LX-4000 Series

+	-	+	-
	A		B

-24/-48/-60 VDC 1.2 MAX

																Modem Port
															RCV		LINK
																	TELCO
																	LINE
17	18	19	20	21	22	23	24		25	26	27	28	29	30	31	32	DIAG RCV LINK
																	100
1	2	3	4	5	6	7	8		9	10	11	12	13	14	15	16	10/100 ETHNT
								DIAG Port (Port 0)									100 Mbps

LED

Figure 10 - LX Series 4032 DC Version with Modem Rear Panel

LINK

100-240VAC

1.0A 50/60Hz

25	26	27	28	29	30	31	32	33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48
1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20	21	22	23	24

RCV LINK

10/100 ETH

RCV 10/100 Interface

Figure 11 - LX Series 4048 AC Rear Panel

RCV

The RCV LED is one of two integral LEDs on the 10/100 jack. This yellow LED flashes to indicate receive activity on the link.

LINK

This green LED defaults to a link good indicator. If the link is present and operating, the LED comes ON.

100 Mbps

This green LED indicates speed. If the link is 100 Mbps, the LED comes ON. On LX-4048 units, this LED is on the front of the unit.

Environmental and Installation Considerations

•Unit must be installed in an environment with 5% to 90% humidity, noncondensing, 0° - 40° C (32°-104° F).

•Do not choose a location where the unit will be exposed to direct sunlight or subjected to vibration.

•Do not place an object on the side(s) of the unit that might block airflow through the unit.

451-0308 MRV Communications, Inc. www.mrv.com 19