Multi-Tech Systems FR3060, FR3100/V8 manual Jumper Block Positioning Procedure, Default

MultiFRAD 3000-Series User Guide

E&M Jumper Block Positioning Procedure

A jumper block exists for each voice/fax channel. The jumper block is to the right of each set of channel jacks. The jumper block contains 8-pairs of pins. The jumper plug fits over three pairs of pins on the jumper block. The E&M type number is labeled on the pc board. The jumper plug needs to be centered on the E&M type number. Perform the following procedure to change E&M jumper position.

1Ensure that power is removed from the MultiFRAD.

2Turn the unit up side down and remove the four phillips screws from the cover. Turn the unit right side up and remove the four phillips screws from the back of the top cover.

3Remove the front panel by loosening the two capative phillips screws. Slide the top cover back off the chassis to expose the rear panel.

4To change a jumper position, lift the jumper plug up off the jumper block and move to the new position, ensuring that the center jumper is centered on the E&M type number.

2 (Default)

1,3

4

5

Figure 6. E&M Jumper Block

5Change the jumper position for each voice/fax channel that is connecting to an E&M trunk that is not a type 2.

6Slide the top cover back on to the chassis. Replace the front panel and secure it by tightening the two capative phillips screws.

7From the back of the unit, replace the four phillips screws that secure the top cover. Then, turn the unit up side down and replace the four phillips that secure the top cover.

8Return to your General Cabling Connections Procedure.

18