Chapter 5 - Remote Configuration and Management
LAN-Based
The
1.You must assign an Internet (IP) address for the PC and for each node that will be managed by the configuration program. Refer to the protocol software documentation for instructions on how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command for the PC host name. You should also test the network interface configuration by Pinging another TCP/IP device that is connected to the network.
2.Install the MultiVOIP software on the local PC. When installed click Start Programs MultiVOIP Configuration Port Setup, or
3.The MultiVOIP Port Setup dialog box displays.
Verify that the Communication Type box is set to IP.
In the MultiVOIP IP Address box, enter the IP Address of the remote MultiVOIP.
4.Click OK when you are satisfied with your selections.
5.Run the MultiVOIP Configuration program. Click Start Programs MultiVOIP MultiVOIP Configuration, or
58
