Multiquip SG1400C3-55748 Generator Outputs, Generator Output Voltages, Voltage Selector Switch

GENERATOR OUTPUTS

Generator Output Voltages

A wide range of voltages are available to supply voltage for many different applications.Voltages are selected by using the voltage selector switch (Figure 10). To obtain some of the voltages as listed in Table 9 (see below) will require a fine adjustment using the voltage adjust toggle switch located on the digital control panel.

Voltage Selector Switch

The voltage selector switch (Figure 10) is located on the back side of the Saddle Box Assembly. It has been provided for ease of voltage selection.

120/208 3

277/480	120/240
3	1

Generator Amperage

Table 10 shows the maximum amps the generator can provide. DO NOT exceed the maximum amps as listed.

Table 10. Generator Maximum Amps

Rated Voltage	Line Amps	Total Amps
1Ø 240 Volt	538 amps	1076 amps
3Ø 208 Volt	466 amps	1400 amps
3Ø 480 Volt	202 amps	606 amps

Figure 10. Voltage Selector Switch

. CAUTION

NEVER change the position of the voltage selector switch while the engine is running. ALWAYS place main circuit breaker in the OFF position before selecting voltage and activate voltage change mode switch.

Table 9. Voltages Available

L1 L2 L3 Output	Voltage Selector Switch			Voltage Selector Switch
Terminal Lugs	3-Phase 120/208V Position			3-Phase 480/277V Position
3Ø Line-Line	208V	220V	240V	416V	440V	480V
1Ø Line-Neutral	120V	127V	139V	240V	254V	277V
Voltage Selector Switch Single-Phase 240/120V Position

1Ø Line-Neutral/

Line-Line

120V

Line-Neutral

N/A

N/A

240V

Line-Line

N/A

N/A

NOTICE

Controller has over/under-voltage protection based on 208 V nominal/480 V nominal/240 V nominal voltage.

SG1400c3 studio generator • operation and parts manual — rev. #1 (02/15/12) — page 29