Muratec MFX-3050 manual Loading paper in the tray 1 or optional tray

Loading paper in the tray 1 or optional tray 2

1Pull open the paper tray and load paper.

You can load letterhead with the design side face down. The top edge of the sheet with the logo should be placed at the front of the tray.

2After loading paper, set the paper type and size for the multi- purpose tray. See page 5.8 for copying and faxing or the Software Section for PC-printing.

Notes

• If you experience problems with paper feed, place one sheet at a time in the multi-purpose tray.

•You can load previously printed paper. The printed side should be facing up with an uncurled edge at the front. If you experience problems with paper feed, turn the paper around. Note that print quality is not guaranteed.

Changing the size of the paper in the paper tray

To load longer sizes of paper, such as Legal-sized paper, you need to adjust the paper guides to extend the paper tray.

3

1

2

4

1 paper length guide

2 support guide

3 guide lock

4 paper width guides

1Press and hold the guide lock, and slide the paper length guide to locate it in the correct paper size slot.

2After inserting paper into the tray, adjust the support guide so that it lightly touches the paper stack.

3Squeeze the paper width guides, as shown and slide them to the stack of paper until it lightly touches the side of the stack.

Notes

• Do not push the paper width guides far enough to cause the materials to warp.

•If you do not adjust the paper width guides, it may cause paper jams.

5.6 <Loading originals and print media>