Muratec MFX-3050 manual Replacing the toner cartridge, Cleaning the drum, Maintenance

5Close the front cover. Make sure that the cover is securely closed.

Replacing the toner cartridge

When the toner cartridge is completely empty:

•Toner Empty appears on the display.

•The Status LED blinks red.

•The machine stops printing. Incoming faxes are stored in memory.

At this stage, the toner cartridge needs to be replaced.

Note

You can set the machine to disregard the Toner Empty message and to continue printing. See page 13.6.

1Open the front cover.

2Pull the toner cartridge out.

3Remove the new toner cartridge from its bag.

4Remove the packing tape and roll the cartridge 5 or 6 items to distribute the toner.

Thoroughly roll the cartridge to assure maximum copies per cartridge. Save the box and the plastic bag for shipping.

Note

If toner gets on your clothing, wipe it off with a dry cloth and wash clothing in cold water. Hot water sets toner into fabric.

Caution

Do not touch the green underside of the toner cartridge. Use the handle on the cartridge to avoid touching this area.

5Hold the toner cartridge by the handle and slowly insert the cartridge into the opening in the machine.

Tabs on the sides of the cartridge and corresponding grooves within the machine will guide the cartridge into the correct position until it locks into place completely.

6Close the front cover. Make sure that the cover is securely closed.

Cleaning the drum

If there are streaks or spots on your print, the OPC drum of the toner cartridge may require cleaning.

1Before starting the cleaning procedure, make sure that paper is loaded in the machine.

2Press Menu until System Setup appears on the bottom line of the display and press OK.

3Press the Scroll buttons until Maintenance appears and press OK.

4Press OK when Clean Drum appears.

The machine prints out a cleaning page. Toner particles on the drum surface are affixed to the paper.

If the problem remains, repeat steps 1 through 4.

13.5 <Maintenance>