N-Tron 9000 Series user manual 17/2007 106

NOTES

A port can be a member to several VLANs, but can only have one PVID

Set Backpressure

Command Name	port set backpressure
Description	Enables or disables backpressure on a given port. This is normally used on
	10Base setups and is a controlled by the hardware.
Syntax	port set backpressure <port-no><enable disable>
Parameters	port-no
	port number (1 ~ 24)
	enable disable
	Backpressure enable or disable
Examples	N-TRON/Admin#[1]> port set backpressure 6 enable
NOTES	Check whether port-nois in the valid range. (1 ~ 24)
Set Intruderstate
Command Name	port set intruderstate
Description	Enables or Disables the intruder log.
Syntax	port set intruderstate <enable disable>
Parameters	enable disable
	Enable or disable the intruder log
Examples	N-TRON/Admin#[1]> port set intruderstate enable
NOTES	This must be enabled for the intruder log to log anything.
Set Priority Level
Command Name	port set prioritylevel
Description	Sets the priority level of a given port.
Syntax	port set prioritylevel <port-no><level>
Parameters	port-no
	port number (1 ~ 26)
	level
	priority level (0 ~ 7)
Examples	N-TRON/Admin#[1]> port set prioritylevel 6 7
NOTES	Priority State should be enabled to use this feature.
Show Configuration
Command Name	port show config
Description	Displays basic configuration settings on given ports.
Syntax	port show config <port-no all>
Parameters	port-no all
	port number (1 ~ 26), you may enter all to see all the ports at once.
Examples	N-TRON/Admin#[1]> port show config all
NOTES	Check whether port-nois in the valid range. (1 ~ 26)
Show Intruders
Command Name	port show intruder
Description	Displays a list of MAC addresses that were not allowed on the network.
Syntax	port show intruder
Parameters	None
Examples	N-TRON/Admin#[1]> port show intruder
NOTES	Intruder log must be enabled before this will log anything.
Show Link Utilization
Command Name	port show linkutilization
Description	Shows the utilization statistics for all the ports including %bandwidth, %in,
	%out, RX bytes, and TX bytes for each port.
Syntax	port show linkutilization
Parameters	None
Examples	N-TRON/Admin#[1]> port show linkutilization
NOTES	%Bandwidth is the %in or %out value that is higher, not the average value.

5/17/2007 page 106 of 138