N-Tron 9000 Series user manual 17/2007 105

NOTES

Auto negotiation mode is : [disabled]

Check whether port-nois in the valid range. (1 ~ 24)

Set Auto-negotiation State

Command Name	port set autonego
Description	Sets the auto negotiation mode of a given port to either enable or disable. If
	the port auto negotiation mode is enabled, the switch can automatically
	adjusts it speed and duplex mode to the incoming speed and duplexmode.
Syntax	port set autonego <port-no><enable disable>
Parameters	port-no
	port number (1 ~ 24)
	enable disable
	Auto negotiation enable or disable
Examples	N-TRON/Admin#[1]> port set	autonego 6 enable
	Auto negotiation mode of port[6] is : [enabled]
	N-TRON/Admin#[2]> port set	autonego 24 disable
	Auto negotiation mode of port[6] is : [disabled]
NOTES	Check whether port-nois in the valid range. (1 ~ 24)
Set Priority State
Command Name	port set prioritystate
Description	Enables or Disables the Priority State on a per port basis.
Syntax	port set prioritystate <enable disable><port-no>
Parameters	port-no
	port number (1 ~ 26)
	enable disable
	Priority State enable or disable
Examples	N-TRON/Admin#[1]> port set prioritystate enable 6
NOTES	Check whether port-nois in the valid range. (1 ~ 26)
Set Flow Control
Command Name	port set flowcontrol
Description	Enable or Disable flow control (typically refers to 100Base). When
	enabled a pause frame will be sent to help control the flow.
Syntax	port set flowcontrol <port-no><enable disable>
Parameters	port-no
	port number (1 ~ 24)
	enable disable
	Flow Control enable or disable
Examples	N-TRON/Admin#[1]> port set flowcontrol 6 enable
NOTES	Check whether port-nois in the valid range. (1 ~ 24)
Set Name
Command Name	port set name
Description	Changes the name of the port. This change will only be visible in the CLI.
Syntax	port set name <port-no><name>
Parameters	port-noport number (1 ~ 26)
	name A string that describes the port
Examples	N-TRON/Admin#[1]> port set name 6 waterplant
NOTES	This will be reset if you change a slot configuration.
Set PVID
Command Name	port set pvid
Description	Set a port’s VLAN-ID.
Syntax	port set pvid <port-no><pvid-number>
Parameters	port-no
	port number (1 ~ 26)
	pvid-number
	The VLAN-ID number of the VLAN that this port will be a member of
Examples	N-TRON/Admin#[1]> port set pvid 6 2
5/17/2007		page 105 of 138