N-Tron 9000 Series user manual 17/2007 103

Show port statistics

Command Name	port show stats
Description	This command is used to get the port statistics of a given port for all
	available counters.
Syntax	port show stats <port-no>
Parameters	port-no
	Port number. (1 ~ 26).
Examples	N-TRON/Admin#[1]> port show stats 5
	--------------------------------------------
	COUNTER TYPE	:[]
	--------------------------------------------
	COUNTER NAME	COUNTER VALUE
	--------------------------------------------
	byteFrames	28072
	64 byte Frames	272
	64-127 byte Frames	24
	128-255 byte Frames	43
	256-511 byte Frames	43
	512-1023 byte Frames	0
	1024-1518 byte Frames	0
	1519-1522 byte Frames	0
	… … … …
NOTES	Check whether port-nois in the valid range. (1 ~ 26)
Get total number of good frames received
Command Name	port get totalgoodframes
Description	Gets the total number of good frames received on the switch.
Syntax	port get totalgoodframes
Parameters	None
Examples	eg.1
	N-TRON/Admin#[1]> port get totalgoodframes
	Total no of good frames: [12456]
NOTES
Get port speed
Command Name	port get speed
Description	Gets the port speed in megabits.
Syntax	port get speed <port-no>
Parameters	port-no
	Port number. (1 ~ 26).
Examples	N-TRON/Admin#[1]> port get speed 4
	port speed of port no [4] is : [10]
	N-TRON/Admin#[2]> port get speed 5
	port speed of port no [5] is : [100]
NOTES	Check whether port-nois in the valid range. (1 ~ 26)
Set Port Speed
Command Name	port set speed
Description	Sets the port speed of a given port.
Syntax	port set speed <port-no><speed>
Parameters	port-no
	Port number. (1 ~ 26)
	speed
	Speed of the port. Speed must either 10, 100, 1000 megabits per sec.
Examples	N-TRON/Admin#[1]> port set speed 5 10
	N-TRON/Admin#[2]> port set speed 9 100
NOTES
Get the port duplex mode
Command Name	port get duplexmode
Description	Gets the port Duplex mode (FULL_DUPLEX / HALF_DUPLEX ) for a
	given port number .
Syntax	port get duplexmode <port-no>

5/17/2007 page 103 of 138