Napoleon Fireplaces GD19P, GD19N manual TABLE of CONTENTS, Retain This Manual For Future Reference

2

TABLE of CONTENTS

PG 2-5 INTRODUCTION		25	BLOWER INSTALLATION
	Warranty	25	NIGHT LIGHTTM REPLACEMENT
	General Instructions
	General Information	26-27	FINISHING
	Care of Glass and Plated Parts		Glass Door Installation and Removal
	Dimensions		Log Placement
5-15	VENTING		Logo Placement
			Control Functions
	Venting Lengths and Air Terminal Locations
	Typical Vent Installations	28	WIRING DIAGRAM
	Special Vent Installations
		29	OPERATION / MAINTENANCE
	Minimum Air Terminal Location Clearances
	Venting Application Flow Chart		Operating Instructions
	Venting Specifications		Maintenance
	Top Exit Conversion	30	ADJUSTMENTS
16-23	INSTALLATION
			Pilot Injector and Orifice Replacement
	Wall and Ceiling Protection		Venturi Adjustment
	Horizontal Installation		Flame Adjustment
	Vertical Installation		Flame Characteristics
	Using Flexible Vent Components
	Fireplace Vent Connection	31-32	REPLACEMENTS
	Using Rigid Vent Components		Ordering Replacement Parts
	Restricting Vertical Vents
			Replacement Parts
	Mobile Home Installation
			Terminal Kits
	Gas Installation
			Accessories
	Optional Wall Switch Installation
	Framing	33-34	TROUBLE SHOOTING GUIDE
	Minimum Mantel and Enclosure Clearances	35	SERVICE HISTORY
24	FRONT FACING AND INSERT KIT
		36	NOTES

RETAIN THIS MANUAL FOR FUTURE REFERENCE

!WARNING

•Do not burn wood or other materials in this fireplace.

•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the fireplace.

•Clothing or other flammable material should not be placed on or near the fireplace.

•Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.

•Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.

•Even after the fireplace is out, the glass and/or screen will remain hot for an extended period of time.

•Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the floor.

•Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.

•It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplace and venting system are kept clean. The fireplace and its venting system should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fireplace area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.

•Under no circumstances should this fireplace be modified.

•This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.

•Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.

•Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.

•Do not strike or slam shut the fireplace glass door.

•This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

•Pressure relief doors must be kept closed while the fireplace is operating to prevent exhaust fumes containing carbon

monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fire.

• Only doors/optional fronts certified with the appliance shall be used.

NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.

W415-0612 / C / 01.25.08