25
BLOWER INSTALLATION
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
If an optional blower is to be used, the blower must be connected to the main power supply. Route a grounded 14 gauge 2- wire power cable to the junction box and ground. At the point where the cable enters the junction box, a conduit connector must be provided.
1.Remove the two screws that secure the control panel to the front of the unit.
FIGURE 52
GS66 WIRING DIAGRAM
4. Place the thermal disk assembly onto the stud located at the lower left of the firebox and behind the support bracket.
5. Connect the wiring for the variable speed switch.
VARIABLE SPEED SWITCH
VARIABLE
SPEED SWITCH
KNOB
RED
THERMAL DISK
WHITE
BLACK
WHITE
6. Insert the blower assembly into the left side under the firebox, slide into the clip and place onto the same stud used for the thermal disk assembly. Secure with the lock washer and wing nut supplied. Ensure that the blower does not touch
| WIRE | |
|
| HARNESS |
|
| (included in GS66 kit) |
BLOWER |
| TO |
FIGURE 53 | POWER | |
| SUPPLY | |
2.Connect the black and red wires of the wire harness to the prongs on the blower.
3.Connect the white and black wires of the wire harness to the prongs on the thermodisc.
the base of the firebox, any wiring or | FIGURE 54 |
controls. Ensure that the thermodisc is |
|
touching the wall of the firebox. |
|
HINT: Rest the thermal disk assembly forward against the support bracket.
7.Place the variable speed switch into position and secure with the pal nut supplied. (FIGURE 25) Reinstall the control panel and install the variable speed switch knob.
NOTE: Plug into the receptacle on the right side of the unit.
NIGHT LIGHT™ REPLACEMENT
BULB REPLACEMENT
The GD19 comes equipped with our “Night Light™”. If in the event the lamp or lens needs to be replaced, follow these instructions.
1.Turn off all electrical supply.
2.Remove the front and door from the firebox.
3.Unscrew the lens cover making sure the washer stays in place.
Note: Do not handle the lamp (bulb) with bare fingers, protect with a clean dry cloth.
4.The lamp will pull straight out of the socket. Replace with Wolf Steel Ltd. parts only
5.Replace lens with gasket, lense covers, attach wires to quick connects and replace the door when finished.
THE FIREBOX MUST BE SEALED.
FIGURE 55 When
LENS ASSEMBLY INSTALLATION
1. Remove the door from | KEY HOLE | FIGURE 56 |
the firebox. |
|
|
2.Run the wires up through the lens hole.
3.Align key hole with lens assembly.
4.Snap into place.
5.Replace light shields,
attach the wires and replace the door to the firebox.
LENS ASSEMBLY REPLACEMENT
1. Remove the front door | FIGURE 57 |
and top shield from the |
|
firebox. |
|
2.Compress the retainer fins in with a screw driver while pressing firmly on the top of the light assembly.
3.Once all the retainer fins are pushed in the lens assembly will snap out of place.
