Napoleon Fireplaces GD19N, GD19P manual Venting

5

	DIMENSIONS
FIGURE 1a	FIGURE 1b		FIGURE 1c
		7” DIA.
		4” DIA.
	34 1/8”		21 3/4”
		33 1/8”	19 3/4”
	GAS	26 3/8”
	LINE
	ACCESS
	12”	ELECTRICAL	10	1	/4”
	13”
	15 3/8”	ACCESS	20 1/2”
FIGURE 1d	FIGURE 1e		FIGURE 1f
	34 1/8”	33 7/8”	9”
	9 1/2”
					7” DIA.
	5”				4” DIA.
	2 1/2”
	1 3/4”
	VENTING

VENTING LENGTHS AND AIR TERMINAL LOCATIONS

Use only Wolf Steel, Simpson Dura-Vent, Selkirk Direct Temp or American Metal Amerivent venting components. Minimum and maximum vent lengths, for both horizontal and vertical installations, and air terminal locations for either system are set out in this manual and must be adhered to. For Simpson Dura-Vent, Selkirk Direct Temp and American Metal Amerivent, follow the installation procedure provided with the venting components.

For vent systems that provide seals on the inner exhaust flue, only the outer air intake joints must be sealed using red high temperature silicone (RTV). this same sleant may be used on both the inner exhaust and outer intake vent pipe joints of all other approved vent systems except for the exhaust vent pipe connection to the fireplace flue collar which must be sealed using the black high temperature sealant Mill Pac.

The connection between the adaptor for these systems and the fireplace flue collar must be sealed using the black high temperature sealant Mill Pac (not supplied).

A starter adaptor must be used with the following vent systems and may be purchased from the corresponding

supplier:
PART	4"/7"	SUPPLIER
Duravent	W175-0053	Wolf Steel
Amerivent	4DSC-N2	American Metal
Direct Temp	4DT-AAN	Selkirk

ForSimpsonDura-Vent,SelkirkDirectTempandAmerican Metal Amerivent, follow the installation procedure found on the website for your venting supplier:

VENTING SUPPLIER	WEBSITE ADDRESS
Simpson Dura-Vent	www.duravent.com
Selkirk Direct Temp	www.selkirkcorp.com
American Metal Amerivent	www.americanmetalproducts.com

W415-0612 / C / 01.25.08