24
FRONT FACING AND INSET KIT INSTALLATION
FIGURE 45 | 3. | Hook the bottom | FIGURE 48 | ||
| of the front facing 5 |
| |||
| on the bottom lip of |
| |||
| the firebox. Pivot the |
| |||
| front | facing | against |
| |
| the firebox and insert |
| |||
| the head of the turn |
| |||
| button | 7 through the |
| ||
| slot in the front facing. |
| |||
| (FIGURE 48) | Secure |
| ||
| by | turning the head |
| ||
| of the turn button 1/4 |
| |||
| turn. |
|
|
| |
WARNING:
The components in this kit are heavy, use care when lifting and ensure they are firmly secured once installed.
This front facing does not replace the main glass door. Do not operate without the main glass door installed.
The front facing can sit flush with a counter, floor, or
hearth.
1.Secure the insets 1 2 and screens 3 to the front facing
5 with the locktooth washers and hex nuts supplied.
FIGURE 46
2.Install the turn button 7 to the face of the firebox using the 2 flat head screws supplied.
7 |
FIREBOX |
FIGURE 47
FIGURE 49 4. Clip the keystone 6 over the band of material and centre on the magnet.
5.While angling the bottom inset, insert the side tabs on the bottom inset 4 behind the side edges of the control panel opening.
FIGURE 50
6.Close the bottom inset assembly 4 against the magnet to hold closed.
FIGURE 51
